Briefly understand the operation method of gantry drilling machine Release time：2021-12-07 12:56:32 Number of views:365

The main function of the chip removal device of the gantry drilling machine is to discharge the chip from the processing area outside the gantry drilling machine. The chip on the gantry drilling machine and grinding machine is often mixed with the cutting fluid. The chip removal device separates the chip from the chip, and the gantry drilling machine sends it into the chip collection box (car), and the gantry drilling machine and the cutting fluid circulate to the cutting fluid tank. For the rough machining of the blank, we should care about how much power the machine has, that is, how much is the feed speed. Because the rough machining of the gantry drilling machine is rough, the precision is not high, but the efficiency is very high, so the gantry drilling machine is required to have strong performance and large specific volume. Let's take a look at the operating procedures that the operators need to remember before starting the operation.

 1, before operation, we should check whether the handles and buttons of various parts of the gantry drilling machine are normal, add lubricating oil according to the regulations, and run at low speed for 1 to 2 minutes.

 2, wear work clothes and hats before work. It is strictly prohibited to wear gloves during operation.3, the clamping workpiece should be smooth. The loading and unloading of the gantry drilling machine, the cutting tool, the measurement, the transmission, the tightening and cleaning of the spindle should be carried out after the gantry drilling machine is shut down.

 4, it is forbidden to place tools, measuring instruments, workpieces and other sundries on the worktable.

 5, when the machine is turned on, check whether the mutual position of the workpiece and the milling cutter is correct.

 6, when the gantry drilling machine moves the tool automatically, the handle and thread need to be disconnected; The worktable can not go two positions, and the limit block must be firmly installed.

 7, when the gantry drilling machine is running, it is forbidden to clean the machine by hand or cotton yarn.It can not stand in the tangential direction of the milling cutter, let alone blow the chip with the mouth.

 8, the tool carrier, the pull rod, the chuck and the cutting tool are installed and tightened before the machine is started, and the spindle shall not be used for auxiliary loading and unloading.

 9, after the use of the gantry drilling machine, turn off the power supply, clean the machine, put the milling head in the empty position, and move the worktable to the center position.

 The correct use of the gantry drilling machine can reduce the casualties of the machine to the staff and prolong the service life of the milling machine.The normal maintenance of the gantry drilling machine can reduce the machine failure and improve the production efficiency.